Produce features:
l Dual battery input design, automatic switching and balancing between batteries,Avoid accidents caused by bad contacts using a single block powered battery.
l Compared with the traditional mechanical switch integrated electronic switch has a higher security and stability.
l Twelve channels for input, connect up to 34 servos, one channel CDI remote flameout switch.
l Each channel has a signal buffer and amplification
l Built-in the a remote CDI flameout switch, makes flying safer
l Independent CDI power supply socket. Receiver power completely separates with the CDI power, so you should not worry about that CDI arouses high frequency signal will interfere the receiver.
l Input / output power is communicated directly, so the input voltage equal to the steering gear and receiver power supply voltage, simply use the different voltage values of the battery can be adapted to a variety of high and low voltage actuator and receiver.
l Independent 5V linear regulator which provide a separate pure working power supply to the receiver.
l Built-30ABEC (Max: 40A), servos provides adequate pure operating current
l 4.8-9.7V output voltage, adapt to a variety of high and low voltage servos
l Dedicated receiver placement, avoid receiver damage due to accidental bombing
l Real-time display of the voltage value; under voltage sound and light alarm
Technology parameters:
l Working voltage: 6-12.6V
l Servos work of current, voltage :0-30A, 4.8-9 .7 V (factory voltage is 5.2V)
l Weight:180g
l Volume:150mm(long)*80mm(wide)*20mm(height)
l Working temperature:-20℃ to 85℃.
| CDI signal states of the power supply: | |||
| The green light on | The green light flash | The red light on | The red light flash |
| Voltage above 4.8V | 4.5V-4.8V | 4.2V-4.5V | Voltage below 4.2V |
Function description:
|
A |
1-12 input channel |
|
|
B |
CDI remote flameout switch control channel / switch of remote controller channel |
|
|
C |
CDI working power indicator light. |
|
|
D |
CDI power input terminal. |
|
|
E |
CDI power output terminal. |
|
|
F |
CDI power voltage indicator light. |
|
|
G |
The voltage alarm settings button |
|
|
H |
Battery 2 input |
|
|
I |
The power supply switch of the board |
|
|
J |
Battery 1 input |
|
|
K |
Regulate output voltage value: 4.8-9.7V |
|
|
L |
Alarm LED interface |
